Sheetcam TNG postprocessor for simCNC
We prepared a dedicated postprocessor for the SHEETCAM TNG software for those using simCNC control software in their plasma cutters.
The postprocessor is prepared so that the cutting process parameterization is done at the cutting place, i.e., from the level of simCNC control software.
Parameterization can be done by:
- manual change of parameters from simCNC screen for plasma cutters.
- through cutting parameters table available in simCNC software.
This solution saves time because an operator does not need to use the SHEETCAM TNG software when changing the cutting parameters.
It means that the postprocessor generates a gcode in which all cutting parameters are omitted except for the ‘Rapid clearance’ parameter.
This is the only parameter that needs to be set in the SHEETCAM TNG software settings.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article